How To Splice Wires

Do not use a utility knife as you risk cutting into the individual wires. The first two splices require that about a half-inch of the insulation be removed from both of the wire ends.

Splice Cable Like A Rocket Scientist 5 Steps With Pictures Instructables

If you notice a wire thats not making contact its best to snip all the twisted ends off strip the insulation and start fresh.

How to splice wires. Bend the tips of the wire so they make little hooks. Strip back about 34 of an inch of insulation from both wires. Slide it onto one of your wires and move it down out of your way a bit.

To avoid this you have to hold the wires firmly while twisting them together and then watch to be sure the wires are making good contact. A plastic connector called a wire nut is used to insulate and secure the splice. A splice is the joining of two or more wires by twisting them together.

For intermediate-sized electrical wires such as 14 copper wire a 15-Amp electrical circuit or 12 copper wire a 20-Amp electrical circuit you can usually strip about 34 of bare wire special stripping tools are available that wont damage the wire or you can work carefully with wire cutters or a knife and you can twist your wires together clockwise by holding the wires in one hand and twisting the bare ends using a single pair of pliers. Ad Edit MP4DVDMTSMKVVOBAVIWMV Video etc. The ends are twisted together to form a good mechanical bond between the wires.

Insert the cable into the hole on the cable ripper until it is about 6 inches from the end of the cable. Second a one and an eighth steel cable is eye spliced by hand. When splicing insulated wire you have to strip the insulation from the end of the wire to expose the metal core which may be solid or stranded copper.

Retwisting wires can break them causing a broken circuit or arcing. Use a wire nut size appropriate for the number and gauge of the wires youre using. A stand with alligator clips can be homemade or purchased to hold.

Add a section of shrink tubing onto the wire. Wire splice connections must be housed inside a covered electrical box known as a junction box. Strip about 14 of shielding from the end of each wire.

These connectors are designed to be used with ordinary pliers. To splice wires youll need a pair of wire strippers solder iron electrical tape and a steady hand. This video is a demonstration on how to properly connect and use a quick splice wire connector.

Something to splice 1 thumb and 1 finger per hand Hemostats or needle nose pliers and maybe some gloves see below Wire stripping utensil Solder Soldering Iron Insulating material heat shrink tubing recommended let me go off on a green note for a moment my wire was scavenged from an old computer power supply if you see anyone throwing away an old pc snag it its LOADED with wire thats good for jumper wires. Lightly press the sides of ripper together and draw the tool off the end of the cable to slice through the sheathing. Wiring splices are made by joining the bare-metal ends of wires together.

The best way to strip wires is to use a pair of basic wire strippers. First a half inch choker is spliced and pressed together using ferrules. Give the wires a twist so the strands are all neat and tidy.

Dont forget this step or youll regret it after youve finished the splice Divide the bare strands into two equal sections and form them into a Y. Ad Edit MP4DVDMTSMKVVOBAVIWMV Video etc.

Mo Wrenching How To Properly Splice Wires